Prehled zarizeni na ktera se da nahrat tzv. OpenWRT firmware:
http://wiki.openwrt.org/toh/start

Obecne navody v cestine:
http://wiki.openwrt.org/cz/doc/start


===Nastaveni TP-LINK WR741ND s OpenWRT firmware pro overovani 802.1x na WAN portu==

zde stahnete OpenWRT firmware
http://wiki.openwrt.org/toh/tp-link/tl-wr741nd

Pozor na verzi vaseho routeru! Najdete ji na nalepce se seriovym cislem a dalsimi informacemi na spodni strane routeru.

V soucasne dobe se prodava v4.25 a pro nej je spravna verze fw primo tady:

http://downloads.openwrt.org/snapshots/trunk/ar71xx/openwrt-ar71xx-generic-tl-wr741nd-v4-squashfs-factory.bin


/etc/opkg.conf:

  src/gz barrier_breaker http://downloads.openwrt.org/attitude_adjustment/12.09/ar71xx/generic/packages
  dest root /
  dest ram /tmp
  lists_dir ext /var/opkg-lists
  option overlay_root /overlay


/etc/wireless:

  config wifi-device  radio0
	option type     mac80211
	option channel  11
	option hwmode	11ng
	option path	'platform/ar933x_wmac'
	option htmode	HT20
	list ht_capab	SHORT-GI-20
	list ht_capab	SHORT-GI-40
	list ht_capab	RX-STBC1
	list ht_capab	DSSS_CCK-40
	# REMOVE THIS LINE TO ENABLE WIFI:
	#option disabled 1
  
  config wifi-iface
	option device   radio0
	option network  lan
	option mode     ap
	option ssid    nazev_site
	option encryption psk2
	option key 'heslo'


/etc/network:

  config interface 'loopback'
	option ifname 'lo'
	option proto 'static' 
	option ipaddr '127.0.0.1'
	option netmask '255.0.0.0'
  
  config globals 'globals'
	option ula_prefix 'fd27:d8e5:8c95::/48'
  
  config interface 'lan'
	option ifname 'eth0'
	option type 'bridge'
	option proto 'static'
	option ipaddr '192.168.1.1'
	option netmask '255.255.255.0'
	option ip6assign '60'
  
  config interface 'wan'
	option ifname 'eth1'
	option proto 'dhcp'
  
  config interface 'wan6'
	option ifname '@wan'
	option proto 'dhcpv6'
  
  config switch
	option name 'switch0'
	option reset '1'
	option enable_vlan '1'
  
  config switch_vlan
	option device 'switch0'
	option vlan '1'
	option ports '0 1 2 3 4'


	
/etc/wpa.conf:



  ctrl_interface=/var/run/wpa_supplicant
  ctrl_interface_group=root
  ap_scan=0
  network={
	key_mgmt=IEEE8021X
	eap=PEAP
	phase2="auth=MSCHAPV2"
	identity="studentske_cislo"
	password="eduroam_heslo"
	ca_cert="/etc/ssl/addtrustexternalcaroot.crt"
	}




/etc/init.d/wpa:

  #!/bin/sh /etc/rc.common
  # Example script
  # Copyright (C) 2007 OpenWrt.org
  START=99
  
  start() {
  echo start
  wpa_supplicant -D wired -i eth1 -c /etc/config/wpa.conf &
  }



[[cs:certifikat|Certifikát]]\\